Page 33 of 40
COLORado PXL Bar 16 User Manual Rev. 1
Operation
Display Orientation
To set which way the display faces, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
Screen Reverse
.
3. Select
NO
(display is normal),
YES
(display is inverted), or
AUTO
(the display automatically
detects which way the product is facing and orients itself accordingly).
Tilt Angle Range
To set the range of motion the tilt is permitted, do the following:
1. Go to the
Setup
main level.
2. Select
Tilt Angle
.
3. Select
200
(200° tilt),
180
(180° tilt), or
60
(60° tilt).
Blackout on Tilt Movement
To set whether the product will black out during tilt movement, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
BL. O. T Move
.
3. Select
NO
(do not black out) or
YES
(black out during movement).
Backlight Timer
To set the amount of time after inactivity before the display backlight turns off, do the following:
1. Go to the
Setup
main level.
2. Select
Backlight Timer
.
3. Select
30S
(after 30 seconds of inactivity),
1M
(after 1 minute of inactivity),
5M
(after 5 minutes of
inactivity), or
ON
(does not turn off).
Loss of Data
In case of any loss of input signal, the COLORado PXL Bar 16 will respond in one of two ways: The
product will either hold the last signal received, or black out all LED output.
To set how the product responds, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
Loss of Data
.
3. Select
Hold
(hold last signal received) or
Close
(black out all LED output).
Fan Speed
To set the speed of the fans, do the following:
1. Go to the
Setup
main level.
2. Select
Fans
.
3. Select
Auto
(fan speed set according to product temperature),
Full
(maximum speed), or
ECO
(quiet fan mode).
Defrost Fan
To activate or deactivate the defrost fan, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
Defrost Fan
.
3. Select
OFF
(deactivate defrost fan) or
ON
(activate defrost fan).
Color-Mixing Mode
The COLORado PXL Bar 16 has a mode that emulates CMY (cyan, magenta, and yellow) color mixing. In
this mode, the dimming is reversed (000 = 100%, 255 = 0%), and the red, green, and blue channels control
cyan, magenta, and yellow, respectively.
To set the color-mixing mode, do the following:
1. Go to the
Setup
main level.
2. Select
C Mixing Mode
.
3. Select
RGBW
(additive mode: 0–100%) or
CMY
(subtractive mode: 100–0%).
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
Dimmer Curve
.
3. Select
Linear
(increase in light intensity is linear),
Square
(light intensity control is finer at low levels
and coarser at high levels),
I Squa
(light intensity control is coarser at low levels and finer at high
levels), or
SCurve
(light intensity is finer at low and high levels, and coarser at medium levels).
