Page 35 of 40
COLORado PXL Bar 16 User Manual Rev. 1
Operation
USB Update
The COLORado PXL Bar 16 allows for software update through USB using the built-in USB port. To enable or
disable this function, follow the instructions below:
1. Go to the
Setup
main level.
2. Select
USB Update
.
3. Select
NO
(disables updating by USB) or
YES
(enables updating by USB).
To update the software using USB flash drive, do the following:
1. Power on the fixture and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message “Upgrade Firmware” will be displayed.
Press <
ENTER
>.
•
If a different message appears on the display, search for the updated software in the
Menu
(Updated Firmware)
. A list of the updated software files will be displayed.
3. Select the file that needs to be uploaded. The message “Are you sure?” will be displayed.
Press <
ENTER
>.
4. If the selected file is correct, the upgrade will be completed. Restart the fixture.
•
If the selected file is incorrect, the upgrade will fail, and the display will go back to the main
interface. Repeat steps 1–3 using the correct file.
System Information
All the information about the current status of the COLORado PXL Bar 16 is available through the product’s
Information
menu. To view this information, follow the instructions below:
1. Go to the
Information
main level.
2. Choose the desired information from the following:
•
Firmware Version
– displays the current firmware version
•
Running Mode
– displays the current running mode
•
Address
– displays the current starting address
•
Temperature
– displays the current product temperature in °C
•
Fixture Time
– displays the number of hours the fixture has been powered on
•
LED Hours
– displays the total hours the LED has been powered on
•
ArtNet Info
– displays the current IP address, Subnet Mask, and MAC address
•
Device UID
– displays the product UID
•
Fan Information
– displays the speed of head fans, defrost fans, and base fans
Offset Mode
The offset mode provides fine adjustments for the home position of all the moving parts in the optical path
and the tilt movements. This ensures that the moving parts do not show any border or reduce the light
output when in their home position.
1. Starting from the Main Level screen, press and hold <
MENU
> until the passcode screen appears.
2. Enter the passcode
2323
.
3. This direct the user to the Zero Adjust menu screen.
Tilt
To adjust the starting point of the tilt motor, do the following:
1. Select
TILT
.
2. Increase or decrease the starting value, from
000
to
255
.
Zoom
To adjust the starting point of the zoom motor, follow the instructions below:
1. Select
ZOOM1
or
ZOOM2
.
2. Increase or decrease the starting value, from
000
to
255
.
MAC Address
To adjust the fourth, fifth, and sixth digit of the MAC address, do the following:
1. Select
MAC4
,
MAC5
, or
MAC6
.
2. Increase or decrease the starting value, from
000
to
255
.
The .chl format file needs to be placed in the COLORADO folder in the USB flash drive.