C H A R B R O I L.C O M
Page 8
USE AND CARE
NOTE: Your grill may NOT be equipped with a Sideburner!
Sideburner Ignitor Lighting
•
Do not lean over grill while lighting.
1.
Turn gas burner control valves to (off).
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Turn sideburner knob to the HIGH position, push and hold ELECTRONIC
IGNITOR button.
5.
If sideburner does NOT light within 5 seconds, turn knob to off, wait 5
minutes, then repeat lighting procedure.
Sideburner Match Lighting
•
Do not lean over grill while lighting.
1.
Turn gas burner control valves to (off).
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Place lit match near burner. Immediately turn sideburner knob to the HIGH
position. Be sure burner lights and stays lit.
•
Putting out grease fires by closing the lid is not possible. Grills are well
ventilated for safety reasons.
•
Do not use water on a grease fire. Personal injury may result. If a grease fire
develops, turn knobs and LP cylinder off.
•
Do not leave grill unattended while preheating or burning off food residue on HI.
If grill has not been regularly cleaned, a grease fire can occur that may damage
the product.
CAUTION
WARNING
Ignitor Lighting
•
Do not lean over grill while lighting.
1.
Turn gas burner control valves to (off).
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
To ignite, push and turn burner knob to HIGH. Immediately, push and hold
ELECTRONIC IGNITOR button until the burner lights.
5.
If ignition does NOT occur in 5 seconds, turn the burner controls off , wait
5 minutes and repeat the lighting procedure.
6.
Repeat steps 4 and 5 to light other main burners.
Match-Lighting
•
Do not lean over grill while lighting.
1.
Turn gas burner control valves to (off).
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Place match into match holder (hanging from side panel of grill). Light match;
then light burner by placing match through the match light hole on side of grill.
Immediately push in and turn burner knob to the HIGH position. Be sure
burner lights and stays lit.
5.
Light adjacent burners in sequence by pushing knobs in and turning to the
HIGH position.
Turn controls and gas source or tank OFF when not in use.
If ignition does NOT occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure. If the burner does not ignite with the
valve open, gas will continue to flow out of the burner and could accidently ignite
with risk of injury.
CAUTION
Summary of Contents for Signature 463255721
