Page 10
Offsetting
If required, the drawbar on the FM Series can be offset to the left or right or folded for storage.
The machine is offset by unscrewing the T-bar as shown below. The drawbar can then be moved to
the desired location, and the T-bar replaced in a suitable hole. The T-bar must be tightened firmly
to prevent movement of the drawbar and should be checked periodically for tightness.
Semi-offset
Folded for storage
Starting Work
After ensuring all daily checks have been undertaken (see above), and with the engine throttle on idle setting
start the engine by turning the ignition key. Depending on the ambient temperature and engine temperature,
choke may be required. Once the engine is running and choke off, engage drive by increasing the engine
throttle to maximum.
Forward Speed
The forward working speed will depend greatly on the working conditions and nature of the material being
cut. Optimal speed will be in the region of 3-8 km/h (2-5 mph).
Changing the drawbar angle must be undertaken with the engine switched off & the
ignition keys removed. Failure to do so could result in injury or damage to the machine.
As the FM Series use a centrifugal clutch drive system, the engine must be run at maxi-
mum speed AT ALL TIMES when cutting.
