14
OPERATION INSTRUCTIONS
DANGER
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside house, or other
unventilated or enclosed areas. This fire pit consumes air
(oxygen). Do not use in unventilated or enclosed areas to
avoid endangering your life.
Before Turning Gas Supply ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly
or servicing is replaced and fastened prior to starting.
Lighting:
Before Lighting:
Caution: Do not attempt to operate until you have read and understand all General Safety Information
in this manual and all assembly is complete and leak checks have been performed.
Very hot while in a operation!
Never lean over the fireplace while in use.
Do not touch tile of spark guard while the fire pit is in
operation, wait until the fire pit has cooled down after use.
Failure to comply with these instructions may result in
serious bodily injury.
WARNING
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
1) Turn the control knob to the “OFF” position (Figure a).
2) Fully open LP cylinder valve.
3) Push in gas control knob and turn counterclockwise to “IGNITER”
(Figure b) to light the fire pit. If needed, keep depressing and turning control knob
counterclockwise until the heater lights (You should hear a clicking sound).
4) After fire pit lights, release control knob. Push in and turn the control knob to the “HIGH”, then
release control knob. If you want a lower temperature, push in the control knob and turn
counterclockwise to the “LOW” (Figure c).
Note: Improper operation, can cause injury or property damage. If burner fails to remain lit, all valves
should be closed and a waiting period of at least 5 minutes should pass before attempting to light.
1. Fire pit should be thoroughly inspected before each half year use, and by a qualified service person
at least annually. If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the visible portion of the hose before each use of the appliance. If the hose leaks, it must be
replaced prior to operation. Only use the replacement hose assembly specified by manufacturer.
3. The pressure regulator and hose assembly supplied with the appliance must be used. Replacement
pressure regulators and hose assemblies must be those specified by the appliance manufacturer.
E
T
I
N
G
I
L
O
W
H
G
I
H
O
F
F
A
P
A
G
A
D
N
O
Ó
I
C
I
N
G
I
A
T
L
A
E
T
I
N
G
I
LO
W
H
G
I
H
O
F
F
A
P
A
G
A
D
N
O
Ó
I
C
I
N
G
I
A
T
L
A
E
T
I
N
G
I
LO
W
H
G
I
H
O
F
F
A
P
A
G
A
D
N
O
Ó
I
C
I
N
G
I
A
T
L
A
Summary of Contents for FPC-C-02
Page 3: ...3 LP GAS CYLINDER LABEL...
