![background image](http://html1.mh-extra.com/html/champion/100250/100250_operators-manual_2588759017.webp)
17
100250 - 37 TON FULL BEAM LOg SPLiTTER
ASSEMBLY
7) install the Engine and Hoses
NOTiCE
Some hoses may be preassembled by the factory, check your
hoses per below instructions to ensure proper assembly.
Oil Inlet (high Pressure) and Oil Return hoses
–
These hoses are black and have swivel nuts on both ends.
–
The Oil Inlet Hose (19) sends hydraulic oil from the pump to
the control valve/cylinder.
–
The Oil Return Hose (64) returns hydraulic oil from the
control valve/cylinder to the tank.
–
Hose connections do NOT require thread seal tape.
The O-ring seals against the face of the fittings on the
pump and hose.
Suction hose
–
This is the clear hose that connects the hydraulic tank to
the pump inlet.
–
Secure both ends of hose with hose clamps.
Engine
1. Align the 4 holes on the base of the engine with the 4 holes
on the engine mount.
2. Thread an M8×45 bolt (47) through a washer (22), lock
washer (21), and (48) M8 lock nut.
3. Thread bolt and washers through a hole on the bottom of the
engine mount into the engine and add the lock nut.
(Torque to 44 - 52 ft lbs.).
4. Repeat steps 1-3 for the rest of the engine mounting
hardware.
47
21
22
48
Suction hose
5. Using the provided d32 hose clamps (40), connect one end
of the clear oil hose (60) to the hydraulic oil tank (A) just
beneath the engine and the other end to the pump inlet on the
bottom of the pump (B). Securely tighten the clamps on both
ends of the clear hydraulic hose with either a flat head screw
driver or 8mm socket (Torque to 2.9-4.4 ft lbs.).
60
B
A
40
Oil Return (Low Pressure) hose
6. Using the provided inlet connector (7), add 2-3 wraps of new
Teflon® tape to prevent oil leaks. Securely tighten the fitting
with 27mm wrench (Torque to 51.7-66.4 ft lbs.). Make sure
the fitting when fully tightening faces upward as shown.
7
7. Place an o-ring into tank inlet connector installed in the
previous step. Make sure the o-ring is properly placed in the
inner groove. Connect the end of hose (64) to the tank inlet
connector. Securely tighten the end with a 27mm wrench
(Torque to 44 - 52 ft lbs.).
64