100679 - 24 iN. 2-STAgE SNOwbLOwER
ASSEMbLY
17
3. Discharge chute bracket should be placed forward as
shown (for correct placement). Do not overtighten. Connect
discharge chute guide to lower handle with 1 bolt (7-1), and 1
lock nut (7-2) (Fig. 7).
7–2
7–1
Figure 7
Speed Control Connecting Lever
1. Connect the connecting lever and connecting base with cotter
pin (8-1).
2. Connect the connecting lever and speed adjusting handle with
clip (Fig. 8).
8–1
Figure 8
Snow Discharge Support
1. Remove the bolts (9-1) and nuts (9-2) from the top of the
discharge support (Fig. 9). Set aside for next step.
9–1
9–2
Figure 9
Snow Discharge Chute
1. Put the snow discharge chute on the snow discharge support.
Attach the snow discharge support using bolts (9-1) and nuts
(9-2) removed in the prior step (Fig. 10). Fully hand tighten.
Figure 10
Discharge Chute Rotation Lever
1. Remove the R-clip from the gear as applicable. Set aside for a
later step. It may be preinstalled by the factory.
2. Insert the lever through the discharge chute bracket on the
lower handle, and then into the hole of the gear (Fig. 11A).
Figure 11A
