100679 - 24 iN. 2-STAgE SNOwbLOwER
MAiNTENANCE
30
8. Split the drive belt off the pulley. Remove and replace the belt
in reverse order ensuring that the new belt is below the spring
loaded idler pulley (Fig. 45).
Figure 45
9. Place the belt guard back into place and install the bolts
(20 mm/30 mm) that were removed earlier. Once reinstalled,
make sure there is equal distance on both sides between the
pulley and the guard (Fig. 46).
Figure 46
10. Install the plastic belt cover (A) using two M6 × 16 bolts
(B) set aside from an earlier step. Torque until snug. Do not
overtighten or you risk damaging the plastic belt cover
(Fig. 47).
b
A
Figure 47
11. Perform a drive test to confirm everything is in working order.
Repair or Replace friction Disk
NOTiCE
If the snowblower fails to drive with the drive control engaged,
and after performing the drive control cable adjustment fails to
correct the problem, the friction disc may need to be replaced.
NOTiCE
To prevent spillage, remove all fuel from tank by running the
engine until it stops. Do not attempt to pour out fuel from
the engine. Disconnect the spark plug before performing any
service.
Tools required:
–
Size 10 wrench (included).
–
Size 17 wrench (not included).
To remove and replace your snowblower’s friction disc, proceed as
follows:
1. Carefully pivot the snowblower up and forward so that it rests
on the auger housing. Place a piece of cardboard or moving
blanket on the ground before tipping forward. Make sure all
fluids are removed and spark plug is disconnected.
2. Remove the base frame cover (1) from the underside of the
snowblower by removing the six M6 × 16 screws which
secure it (Fig. 48A).
1
Figure 48A
