201185 - 4250W WIRELESS REMOTE START OPEN FRAME INVERTER
CONTROLS AND FEATURES
13
Control Panel
ECO
1.
Intelligauge
– See
Intelligauge
section.
2.
AC Overload Reset Button
– Used to re-energize
receptacles after overload fault.
3.
Low Oil Warning Indicator Light
– When ON, engine will
shut down and not run. Check oil level.
4.
Choke Button
– Used to start a cold engine.
5.
Wireless Set/Reset Button
– Used to reset or pair remote
control(s).
6.
Economy Mode Button
– Enables/disables automatic idle
control.
7.
CO Shield
®
LED
– The CO Shield
®
technology monitors
for accumulation of poisonous carbon monoxide (CO) gas
produced by engine exhaust when the generator is running. If
CO Shield
®
detects elevated levels of CO gas, it automatically
shuts off the engine.
* *See CO Shield section for more information
8.
START/STOP Push Button
9.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
10.
Parallel Outlets
– Used to parallel two inverters together for
increased power output. (parallel kit sold separately).
11.
Ground Terminal
– Consult an electrician for local grounding
regulations.
RECEPTACLES
A
z
12V DC, 8A (Regulated Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
B
t
120V AC, 30A RV (NEMA TT-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
2
3
1
11
4
8
5
6
7
10
A
b
C
9
RECEPTACLES
C
A
(2×) 120V AC, 20A (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. When charging a device, do not place on the exhaust
side of the generator. Extreme heat caused by exhaust
can damage the device and cause a potential fire hazard.
Prolonged exposure to engine exhaust can cause serious injury
or death.
Fuel Dial
1
2
3
1.
Engine Off
2.
Gasoline Off
3.
Gasoline On
