201185 - 4250W WIRELESS REMOTE START OPEN FRAME INVERTER
OPERATION
22
WARNING
Do not expose to rain or use in damp locations.
Keep all objects a minimum of 5 feet (1.5m) away from the
generator at all times. Heat from the muffler surface and
exhaust gas stream can ignite combustible materials.
WARNING
If you must operate in rain or damp locations, DO NOT operate
without proper protection of the electrical components.
Use of a safety canopy that is fire retardant and will provide proper
air ventilation for the engine exhaust gas stream may be used.
Visit championpowerequipment.com or call to find your Storm
Shield cover.
Surge Protection
Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
–
Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They’re designed to protect against virtually all short-duration
voltage fluctuations.
Wireless Set button
The wireless set button is a feature that lets the user synchronize
the remote key fob to the generator. Up to two remote key fobs
can be synchronized to the generator at a time. Follow the
proceeding steps to reset a remote or synchronize two remotes:
1. Turn the fuel dial to the “ON” position.
2. Press the ignition control button to enter standby mode.
3. Push and hold the wireless set button found on the
Intelligauge for approximately three seconds until the button
LED illuminates blue.
4. Push and release the STOP
$
button on the remote key
fob. The green LEDs on the remote key fob and the Ignition
Control Button will blink once simultaneously to indicate
program is erased and generator is ready for pairing.
5. Push and release the START
a
button on the remote key
fob. The green LEDs on the remote key fob and the Ignition
Control Button will blink once simultaneously to indicate the
remote has been programmed.
