201185 - 4250W WIRELESS REMOTE START OPEN FRAME INVERTER
OPERATION
23
6. Push and hold the wireless set button for approximately three
seconds until the blue LED on wireless set button turns off.
7. Follow the remote START and STOP instructions to verify the
remote(s) are working properly.
NOTICE
Two remote key fobs can be synchronized to the generator at
one time.
NOTICE
Changing a remote key fob battery may not require the user to
reset the remote. If remote does not function after changing
the battery, proceed with Wireless Set Button instructions.
Starting the Engine
1. Make certain the generator is on a flat, level surface.
2. Turn the fuel dial to the “ON” position.
Wireless Remote Start
Wireless remote starting is only possible within 80 feet of the
generator.
DO NOT attempt to adjust the choke. The remote system will
automatically close and open the choke.
1. Press the ignition control button to enter standby mode. If
generator was turned off using the remote key fob within the
last 24 hours, it will already be in standby mode.
2. Press and release the “START” button on the remote control.
DO NOT hold the button down, only press the button once.
The engine will attempt to start six times.
Electric Start
1. Press the ignition control button to enter standby mode.
2. Press the ignition control button to start the engine. If engine
does not start, wait at least ten seconds before attempting to
start the engine again.
