201004 - 7500W WIRELESS REMOTE START GENERATOR
OPERATION
21
WARNING
During operation the muffler and exhaust fumes will become
hot. If adequate cooling and breathing space are not supplied,
or if the generator is blocked or enclosed, temperatures can
become extremely heated and may lead to fire.
Wet Conditions Alert:
Do not expose to rain or use in damp
locations except as follows:
If you must operate in rain or damp locations, DO NOT operate
without proper protection of the electrical components.
Use of a safety canopy that is fire retardant and will provide proper
air ventilation for the engines exhaust stream can be used. Keep
all objects a minimum of 5 feet (1.5m) away from the generator at
all times. Heat from the muffler surface and exhaust stream can
ignite combustible materials.
Visit championpowerequipment.com or call to find your Storm
Shield cover.
Surge Protection
Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
–
Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They’re designed to protect against virtually all short-duration
voltage fluctuations.
Wireless Set button
The wireless set button is a feature that lets the user sync remote
key fob to the generator. One can set up to two remotes or reset a
remote with the generator. To reset a remote key fob or sync two
remotes follow these steps:
1. Turn the ignition switch to the “ON” position.
2. Turn the battery switch to the “ON” position.
3. Push and hold the wireless set button for approximately three
seconds until the red light turns on.
4. Push and release the STOP button on the remote. The red
light blinks once to erase the remote program.
5. Push and release the START button. The red light blinks once
to program the remote.
