en-8
Ω
8.2
+
+ -
RED
RED
BLUE
BLUE
230VAC
+
+
+
+
PE
PE
30VDC
MOTOR
MASTER
MOTOR
SECOND 24V/150mA
BRN GRN WHT YEL
MASTER
BRN GRN WHT YEL
SECOND
COM PHOTO
1 2
COM STOP /
8.2KΩ
STOP/8.2KΩ
PHO 1
PHO 2
LEARN
DIAGNOSTIC
CH1
CH2
1/2 MOTOR
STOP/8.2KΩ
OPEN/PED
JP1
JP2
P1
P2
P3
L
N
POWER SUPPLY
230VAC/50Hz
TRANSFORMER
230VAC
INPUT 24VAC
250V/2A
250V/2A
RADIO
STOP/8.2KΩ
PHO 1
PHO 2
EARN
DIAGNOSTIC
CH1
CH2
MOTOR
OP/8.2KΩ
EN/PED
RADI
O MODULE
Model
203285
Mode
l
207399
230V
AC
Antenna
optional
TECHNICAL DATA OF MOTOR CONTROL:
Voltage
230VAC / 50-60 Hz
Transformer
230/24VAC minimum60VA
Output motor
24VDC max.
Supply accessories
24VDC - 100mA
Operating temperature
-20°C - +55°C
Degree of protection
IP54
WIRING OF CONTROL / SUMMARY
a) start with still dead 230Volts supply cable on the left side of the box.
b) Attach cable eye to ground wire. Then connect ground wire to base
plate with washer and nut (exactly as shown in picture detail).
Connect all other cables to control.
c. For the drives: Use cables which are suitable for outside use
(Thickness: 0,75mm²). If needed, use the same cable twice.
Attention:
Check repeatedly that cable colours are connected correctly
to motor. Otherwise motor might be damaged or will not operate
properly. Pay special attention when using distribution boxes.
We recommend the following accessories:
E
ck7
Kit for
cable
extension of one installation unit. Consists of
7
m of
cable 6-pole with identical colours, distribution box IP
44
,cable screw
joints and fastening material
