P1
P2
P3
RADIO
CH1
CH2
1/2 MOTOR
STOP/8.2KΩ
OPEN/PED
JP1
JP2
P1
P2
P3
RADIO
CH1
CH2
1/2 MOTOR
STOP/8 2KΩ
P1
P2
P3
RADIO
3
x
1
2
3
4
5
PROGRAM TX4UNI
Insert radio module on designated pins, if not pre-installed.
The receiver has two channels CH1 and CH2.
The respective LEDs CH1 and CH2 are assigned to these two
channels.
Receiving a signal from a programmed remote control button, CH1
= P1
opens the
gate
partially
.
Receiving a signal from another programmed remote control button,
CH2
= P2
fu
lly opens the gate.
Program the remote control using button P
2
(fully opens the gate, shown adjacent):
1.
Insert jumper “Radio
"
2.
Press and hold l
eft
and right button of the remote control
simultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds. Now select one of 4 buttons
you wish to operate the gate with (do not press yet).
3.
Press button P
2
. LED CH
2
comes on for approx 10 second
s.
4.
Within these 10 second
s
- press now the previously selected button of the remote control
- as control board and remote control are now going to adjust
a
matching code, the button on the remote control must be possibly
pressed a second or third time.
- Once LED CH
2
has flashed twice
proceed with step 5.
5.
Press one of the remaining 3 buttons of the remote control to e
nd
programming using P
2
.
Note: If step 4 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 2.
Up to 180 remote controls can be programmed likewise.
In case no remote control is to be be programmed with
button P
1
, the jumper “RADIO PROGRAM” must now be removed.
Program the remote control using button P
1
(partially opens the gate):
1.
Press and hold l
ef
t and right button of the remote control
simultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds. Now select
another
button
of the remote control to operate only one wing (do not press yet).
2.
Press button P
1
. LED CH
1
comes on for approx. 10 second
s
3.
Within these 10 second
s
- press now the newly selected button of the remote control
- as control board and remote control are now going to adjust
a
matching code, the button on the remote control must be possibly
pressed a second or third time.
4.
Once LED CH
1
has flashed t
hree times
proceed with step 4.
4.. Press one of the remaining 3 buttons of the remote contr
ol
to end programming.
Note: If step 3 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 1.
Up to 180 remote controls can be programmed likewise.
5.. Remove jumper “RADIO
"
DELETE
1.
Insert (connect) Jumper “Radio
"
2.
Press and hold buttons P1 (for CH1) or P2 (for CH2) until t
he
respective LED goes out again (approx. 10 seconds).
Single remote controls can not be deleted. All remotes programmed
to this channel are deleted.
Important: To finish deleting, remove jumper “Radio”
.
en-12
