10
1
2
3
Fig. 1
4
5
Fig. 2
Make sure the garage door is fully closed. Pull the manual release cord
to disengage the trolley. Slide the trolley to around 300 mm from the
lintel bracket.
1.The straight door arm is already preassembled to the trolley.
2.Install the curved arm (1) onto the door bracket using the 23 mm
Clevis pin (2) and R-Clip (3) supplied.
3.Move the straight and curved arms together and secure using two
bolts and nuts provided (4). Ensure the angle of the straight arm is
around 20 degrees from vertical, when the door is fully closed.
.
ATTACH DOOR ARM TO TROLLEY
OPERATING THE MANUAL RELEASE
The manual release mechanism enables the door to be manually operated
during power outages or in an emergency.
The RED Manual Release cord is preassembled to the trolley. When the
opener is installed the handle should be no higher then 1.8 metres from the
floor. The cord may need to be extended.
Attach the manual release
Instruction Label
to the cord as indicated in fig 1.
DO NOT USE THE RED MANUAL RELEASE HANDLE TO OPEN AND
CLOSE THE DOOR.
To operate the Manual Release:
1.The door should be fully closed if possible.
2. Pull and hold the manual release rope down, (fig A) at the same time
lift the door slightly (fig B). This will disengage the door from the trolley.
3. Release the rope and the door can now be opened by hand.
To Re-engage the Door:
1. If power is available, operate the opener with the remote control. When
the trolley passes the door position it will automatically re-engage the
opener and move the door.
2. If no power is available, manually operate the door to the original “position
of disengagement”, and the door will automatically lock in that position.
DO NOT DISENGAGE THE OPENER TO MANUAL
OPERATION WITH CHILDREN , PERSONS OR OTHER
OBJECTS INCLUDING MOTOR VEHICLES WITHIN THE
DOORWAY (The door is under significant tension and if the door has
developed a fault or incorrect tension, it may be unsafe and may fall
rapidly.)
17
18
fig 1.
