Now insert the strap from the front into the flush
mount coiler first underneath the black reel and
then underneath the white reel within (fig.6).
Extract the strap about 30cm on the other side.
Pay attention towards the strap not being twisted
at any point from exiting the wall up to the flush
mount coiler. Insert the strap as shown into the
spool. The strap ending should protrude approx.
3cm (fig.7).
6
7
Reinsert the sleeve into the spool. Reinstall the spool into the flush mount coiler and check correct fit-
ting: the cogs on the edge of the spool reach into the vertical drive shaft (fig.8+9). Insert the extracted
screw back into the fastening of the spool and fasten using a screw driver. Slide the flush mount coiler
into the opening in the wall and readjust it with the screws from the original facing (fig. 10+11).
8
9
10
11
709156-1GB
G
B
-4
