5.0 Installation & Setup
11
5.4 Uncrating
The Titan 200BC weighs approximately 755 lbs (342kg). DO NOT risk personal injury or damage by
attempting to move machinery with makeshift equipment or inadequate manpower. This machine is
shipped on a wooden skid and enclosed in a protective, corrugated top. The skid is designed to allow
the machine to be rolled off without any special lifting equipment. The machine is held in place by
two, 2x4 braces lag bolted to the skid. All accessories are shipped inside of the machine.
Remove the carton by removing the nails or staples holding it to the skid and lift it straight up over the
cutter. If you don’t have the ceiling clearance to do this, carefully slit the carton down the side and
then unwrap it from around the cutter.
Remove all lag screws from the skid. Remove the lower front cover of the Titan 200BC and remove
the two lag screws in the base. Remove the accessories.
Using the rear bumper board, pry one side of the machine up, and slide out the top layer of the
support riser (Figure 4). Do the same on the other side.
Figure 4 (Similar Model)