6.0 Operation
17
6.3 Adjusting the Clamping Pressure
To adjust the clamp pressure, first remove the lower front cover, then start a cut cycle and read the
pressure on the gauge once the clamp has reached the table and the knife starts to come down. It
should read between 400 and 800 psi. Now locate the clamp pressure reducer valve (Figure 11),
loosen the hex jam nut, and turn the adjustment screw with a hex allen wrench to make the
adjustment
– clockwise to increase pressure, or counter-clockwise to decrease pressure. Check the
pressure setting after each adjustment by making a cut and reading the gauge. Always keep the
clamp pressure set between 400 and 800 psi.
Figure 11
– Top View of Hydraulic Unit
6.4 Jogging Aid
Always remove the jogging aid from the table before making a cut.
A jogging aid is included as standard equipment with the Titan 200BC. This tool allows the operator
to load and align paper without the need to place hands or arms under the knife or clamp.
Load the paper against the side and backgauge using the jogging aid (Figure 12 & Figure 13).
Remove the jogging aid from the table, close the shield, and make the cut.
Figure 12
