9.
Sawing operations
After each new adjustment it is advisable to carry out
a trial cut in order to check the set dimensions.
After switching on the saw, wait for the blade to reach
its maximum speed of rotation before commencing
with the cut.
Secure long workpieces against falling off at the end
of the cut (e.g. with a roller stand etc.)
Take extra care when starting the cut!
Never use the equipment without the suction
function. Regularly check and clean the suction
channels.
9.1
Cutting narrow workpieces
(width less than 120 mm) (Fig. 11)
• Adjust the parallel stop (7) to the width of
workpiece you require.
• Feed in the workpiece with two hands. Always use
the push stick (3) in the area of the saw blade (4).
(A push stick is supplied with the saw!)
• Always push the workpiece through to the end of
the splitter (5).
• Caution! With short workpieces, use the push stick
from the beginning.
9.2
Cutting extremely narrow workpieces
(width less than 30 mm)
• Adjust the parallel stop (7) to the width of
workpiece you require.
• Use the push block (d) to press the workpiece
against the stop rail (25) and push the workpiece
with the push stick (3) through to the end of the
splitter (5).
There is no push block supplied with the saw!
(Available from your specialist dealer)
Helpline No 0844 801 8701 / IRE 189 094 6244
16
