Helpline No 0844 801 8701 / IRE 189 094 6244
10
4.
Important notes
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.
The corresponding safety information can also be
found in this instruction manual.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
Idling
L
pA
sound pressure level
95 dB(A)
K
pA
uncertainty
3 dB
L
WA
sound power level
108 dB(A)
K
WA
uncertainty
3 dB
Wear ear-muffs / ear defenders.
The impact of noise can cause damage to hearing.
“The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the user
should at least be able to make a better assessment
of the dangers and risks involved.”
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect working
order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
5.
Technical data
Supply Voltage:
230 V ~ 50 Hz
Power rating:
800 W S2 10 min
Idle speed n0:
2950 rpm
Carbide saw blade:
200 x 16 x 2.4 mm
Number of teeth:
20
Table size:
500 x 335 mm
Cutting height max. 90°:
43 mm
Cutting height max. 45°:
35 mm
Connector for dust extractor:
dia. 35 mm
Size, complete:
500 x 335 x 370 mm
Weight:
13,1 kg
Load factor:
A load factor of S2 10 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (800 W) for no longer than
the time stipulated on the specifications label (10
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
6.
Before starting the equipment
• The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted to
a strong stand.
• All the covers and safety devices have to be
properly fitted before the machine is switched on.
• It must be possible for the saw blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws etc.
• Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine’s moving parts run smoothly.
• Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.