Operation
Please note:
Do not switch off the dispenser as long as a beer keg is still inside. If the dispenser is
switched off with a beer keg still inside, then the beer will no longer be kept fresh and can spoil
quickly.
The LED temperature display (7) shows the actual cooling temperature of the beer keg.
Before dispensing beer, wash out a few beer glasses with cold water.
Make sure that there are no residues, such as a greasy film, left in the glasses.
Hold the beer glass at an angle under the dispensing tap. Make sure that the tip of the dispensing
tap does not touch the beer glass. This will affect the foam formation.
Please note:
The amount of foam formed could be affected depending on the angle the beer glass
is held under the dispensing tap.
Pull the dispensing tap handle (4) forward quickly and completely until it clicks into the foremost
position.
Let the beer run down the inside of the beer glass and slowly straighten the angle of the beer glass
to enable proper filling. Towards the end, the glass should be held under the dispensing tap in a
vertical position. Push the dispensing tap handle (4) back to its original position to close it once the
foam in the beer glass has reached the rim of the glass.
Set the beer glass down under the dispensing tap and wait until the foam has settled.
Continue filling the beer glass until the correct proportions of beer and foam have been reached.
This is the case when the foam head is about two fingers breadth high and slightly over the rim of
the glass.
Repeat this process to fill additional beer glasses.
Disassembly
Once the beer keg has been emptied, remove the CO
2
cartridge from the dispenser first.
To do this, unscrew the CO
2
cartridge holder (13) from the CO
2
cartridge connector (10).
WARNING!
Any leaking CO
2
is very cold! Danger of frost bite!
Please note:
Put a full beer keg into the dispenser before inserting a new CO
2
cartridge.
Push the button (17) on the dispenser to open the lid (1).
Pull the CO
2
connector (20) out of the CO
2
feed valve (19) at the back of the dispenser.
Remove the empty beer keg with the dispensing unit (3) from the dispenser.
Place the beer keg with the dispensing tap next to a wash basin and let the remains of the beer run
out.
Press the keg release plastic lever on the front clamp to
release it (fig. 8).
Pull the dispensing unit (3) a little backwards and upwards,
to release the front clamp (fig. 9).
