14
Chapter III
7. Unpack your MR card, being careful not to touch the gold metal teeth at
the bottom. Carefully insert it into the AMR slot. If the card is difficult to
push in, rock it back and forth while gently applying pressure. do not force
it. After the card is in place, fasten the screw which attaches the card's
metal strip to the rear panel.
8. After you have installed the card, replace and secure the cover with the
screws, reconnect all cables and cords, and then turn on the power.
Thoroughly test your new accessory to make sure it is working properly. If
you have any problems, your dealer will be happy to help you.
3-3 Adding Extra DRAM Memory
The DRAM memory system consists of the two banks and the memory size
ranges from 16~256 MBytes. Only one bank was used and if you want to
add one more DRAM module to the system. Simply do the following steps.
1. Turn off the system power, including the monitor and any peripherals.
2. Disconnect all cables from the rear panel of the main system unit.
Make sure to remember where to plug them in again.
3. Position the unit for easy access to the rear panel and the inside of the
unit.
4. Using a Phillips screw driver, remove the screws from the sides of the
system cover. Make sure not to lose the screws.
5. Lift off the cover and carefully set it aside.
6. Inside the system unit, you should see the DIMM socket.
7. Gently push the memory module downward until side clips are properly
secured to the module.
8. After you have installed the module, replace and secure the cover with
the screws, reconnect all cables and cords, and then turn on the power.
Thoroughly test your new accessory to make sure it is working properly. If
you have any problems, your dealer will be happy to help you.
gentle-pc3.p65
2000/5/22, PM 01:53
14
