Fitting the Access Point
20
Access Point
When fitting the Access Point, you must ensure the following
conditions:
Make sure that the power supply and the power supply cable
can be plugged in.
Make sure that the network cable can be plugged in.
The Access Point must not be fitted on metallic surfaces.
Always install the Access Point as far away from ground
potentials as possible to avoid interference with the radio
traffic.
The Access Point may not be fitted outdoors.
If the range for reading your locking devices is
limited, use the optional additional antenna. See also
Note on page 10.
The Access Point is supplied preassembled. Before fitting, the
Access Point must first be disassembled.
The following tool is required:
Screwdriver with suitable cross tip bit for recessed head
screws (Phillips screws)
In addition, you require suitable fasteners for the Access Point.
The fasteners and the related tools required depend on the
material at the place of installation.
Purchase suitable fasteners material from your specialized
dealer for fastening engineering.
