CERIO software core : cen_v3.0
Manual
– Click the “
Connect
” button on “
WAN Information
” in the Overview page
to connect to the Internet.
Idle Time :
Time to last before disconnecting PPPoE session when it is idle. Enter
preferred Idle Time in minutes. Default is “
0
”, indicates disabled. When Idle time is
disabled, the “
Reconnect
Mode
” will turn out “
Always
on
”
MTU :
By default, it’s
1460
bytes. MTU stands for Maximum Transmission Unit.
Consult with WISP for a correct MTU setting.
MPPE Encryption :
Microsoft Point-to-Point Encryption (MPPE) encrypts data in
Point-to-Point Protocol(PPP)-based dial-up connections or Point-to-Point Tunneling
Protocol (PPTP) virtual private network (VPN) connections.
128
-
bit
key (strong)
and
40
-
bit
key (standard) MPPE encryption schemes are supported. MPPE
provides data security for the PPTP connection that is between the VPN client and
the VPN server.
DNS :
Check “No Default DNS Server” or “Specify DNS Server IP” radial button as
desired to set up system DNS.
Primary :
The IP address of the primary DNS server.
Secondary :
The IP address of the secondary DNS server.
NAT :
The NAT support Enable and Disable Service
MAC Clone :
The MAC address is a 12-digit HEX code uniquely assigned to hardware as
identification. Some ISPs require you to register a MAC address in order to access to
Internet. If not, you could use default MAC or clone MAC from a PC.
