SKU 66435
For technical questions, please call 1-800-444-3353.
Page 10
Note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
To Attach The Wheels To The Back
Floor Stands:
Attach the Wheel Frame (8) to the
1.
two Back Floor Stands (6) using two
Hex Head Screws (3), two Washers
(4), and two Hex Nuts (7).
(See Figure A.)
Attach one Wheel (12) to the Wheel
2.
Frame (8) using one Wheel Bolt
(127), one Washer (4), one Spring
Washer (11), and one Hex Nut (7).
Repeat this step for the remaining
Wheel.
(See Figure A.)
FIGUrE A
WHEEL
FrAME
(8)
HEx
HEAD
SCrEW
(3)
WASHEr
(4)
HEx NUT
(7)
WHEEL
(12)
WHEEL
BOLT
(127)
WASHEr
(4)
SprING
WASHEr
(11)
HEx
NUT
(7)
To Attach The Floor Stand Handle To
The Front Floor Stands:
Insert the Floor Stand Handle (1) into
1.
the two Front Floor Stands (5). Then
use two Cotter Pins (2) to secure the
Floor Stand Handle to the two Front
Floor Stands. Make sure to bend the
Cotter Pins to keep them in place.
(See Figure B.)
FIGUrE B
FLOOr STAND HANDLE
(1)
COTTEr
pIN
(2)
FrONT FLOOr STAND
(5)
To Attach The Bed To The Back Floor
Stands And Front Floor Stands:
Use a proper lifting device to raise the
1.
Bed (55) of the Bandsaw just enough
to insert the tops of the Back Floor
Stands (6) and Front Floor Stands (5)
inside
the corners of the Bed. Make
sure the Back Floor Stands are posi-
tioned at the motor end.
(See Figure C, next page.)
For
2.
each
of the four Floor Stands (5,
6) use two Hex Head Screws (56),
two Washers (4), and one Hex Nut
(7) to secure the Floor Stand to the
Bed (55).
(See Figure C, next page.)