SKU 32206/32208
For technical questions, please call 1-800-444-3353.
PAGE 13
FigUre FOr Step 4-3
3. Slide the Pulley (1C/3D) over the end of
the Motor (11A) shaft, larger end first.
Line up the key slots in both the Pulley
and the shaft. Slide the key into the key
slots. Align the end of the Pulley, key,
and shaft with one another. The Pulley
will need to be held in position for now.
FigUre FOr Step 4-4
For SKU 32208 only
(Cutaway view.)
ShAFt
pU
lle
Y
pU
lle
Y
Ke
Y
Set S
C
re
W
Depth
gAUge
4. (Step for 32208 only.) Hold the Pulley
in place and insert the depth gauge you
made in step 4-2 (Bolt (G) and Nut (N))
into the key slot, pushing the key into
position. The depth gauge can now be
disassembled and placed with the other
hardware.
While holding the Pulley in place, tighten
5.
the Set Screw (3C/10D) in the side of the
Pulley to secure it to the shaft. The Pul-
ley no longer needs to be held in place.
motor mounting
Have an assistant hold the Motor (11A)
6.
in place while it is attached to the Motor
Plate (10A).
FigUre FOr Step 4-7
(32208 shown)
11A
10A
pUlleYS
ShOUlD
liNe Up.
7. There are two sets of slots on the Mo-
tor Plate (10A). Line the Motor Pulley
(1C/3D) up with the Pulley (23B/1D)
above it.
Insert a Bolt (D) and Washer (H) through
8.
each hole from one side, and secure the
Bolt with a Washer (H), Lock Washer (J),
and Nut (K). Leave the Nuts snug, but
do not tighten them completely yet.
Remove the nylon cable tie that secured
9.
the Power Cord (14A) during shipment.
reV 01g
