9
9
Zephiro Fog 3000 User Manual
Eng
1. Power inlet (IEC connector)
2. Fuse
3. On/Off Switch
4. Wired control input
5. DMX 3-Pin XLR Output
6. DMX 3-Pin XLR Input
7. Liquid hose and liquid tank cap
8. DMX dip-switch panel
9. Built-in receiver for remote control
4 - P
roduCT
o
vervIew
4.1. Mains Power & Fuse
Power Inlet (1)
- In case of loss or replacement of the cable, refer to the following
table which shows the correspondence of the internal wires:
Cable (EU)
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth must to be connected! Pay attention to the safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
Fuse Holder (n.2)
- In case you need to replace the fuse, make sure that the appli-
ance is switched off, disconnect the input power plug, and unscrew the fuse holder
cover shown above with a Phillips screwdriver.
CAUTION: Replace the fuse ONLY with one of the same type indicated in the
section
“7 - Specification” on page 15
(T10A/250V - 5x20 mm). A lower value
fuse would blow immediately after the first power on; a higher value would not
act as a fuse in case of anomalous current absorption or short circuit.
WARNING: Always connect the product to a protected circuit (with circuit break-
er). Make sure the machine has an appropriate electrical ground to avoid the
risk of electric shock or fire.
WARNING: Never connect the Zephiro Fog 3000 to a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to
100 % switch.
4.2. DMX Connection
DMX Output (5)
- Female 3-pin XLR sockets for sending the DMX control signal to
another DMX device.
