15
GB
Important!
Positive fit before traction!
First, try to positively load the equipment
(e.g. through striking the sides).
Excessive lashing forces can deform the tank
and thus damage it.
Recommendation:
Use a non-slip mat.
Attention!
Danger of material damage
The lid on these tanks does not have any clamp
locks, but clicks into place only by means of ten-
sioning bolts. The air stream may open the lid and
could rip it off.
Therefore always transport the filling station with
the hinges facing the direction of travel.
i
h
Locking bolt
j
Belt recesses
k
Hinges
l
Direction of travel
8
12
10
11
5.4 Filling the tank
1. Unscrew the cap on the filling opening
a
.
2. Fill the container through the filling opening using
a delivery nozzle with automatic shut-off feature.
3. After the filling, close the filling open tightly again
with the cap
b
.
4. Contamination of the container caused by the
filling process must be removed immediately
with a dry cloth.
b
a
5.2 Loading...
5.2.1 …by hand
An empty DT-Mobil
Easy can be loaded
by hand using the
grip hollows on the
side of the tank.
Observe the 26 kg
weight of the empty
system.
5.2.2 ... with forklift
i
Important!
Use the
moulded
recesses on
the underside
for safe lifting
with a forklift.
5.3 Transporting
During transport, observe the pertinent regulations
for transport and securing loads, in particular:
• road-traffic (licensing) regulations of the
respective country,
• CEN 12195 Parts 1 to 4 for calculation and lashing
On top of the container are three integrated
recesses
j
that serve as belt guides for securing
the DT-Mobil Easy 200 l l to the transport vehicle
with suitable tensioning belts (max. 35 mm mm
wide). The flap lid above can be opened without
restriction.
Fig. 5.2.1: Grip hollow
Fig. 5.2.2: Forklift
10
Summary of Contents for DT-Mobil Easy 200 L
