Warrior Products 4560, Manual

Page: 1 / 4

Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
customerservice@warriorproducts.com
www.warriorproducts.com
● ● ●
OEM Receiver
only
2005 – 2015 Toyota Tacoma Rear 2” Receiver Bumper w/ D-Ring Mounts
P/N 4560
Kit Contents:
Item Qty Item Qty
Rear Bumper 1 Filler Plate / Light mount Bracket 2
M12 x 1.25 x 40mm Hex Bolt 4 ¼” x ¾” Carriage Bolt 4
Large M12 Flat Washer 4 ¼” SAE Washer 8
Lock Washer for M12 Hex Bolt 4 ¼” Nyloc Nut 8
Rubber Trim 36” ¼” x ¾” Hex Bolt 4
Rear Storage Box Cover 1 Plastic License Plate Nut 4
Rear Storage Box Lock Mechanism 1 #14 x 1” Self-Tapping Screw 4
Installation Instructions:
1. Before you start, you must remove the factory rear bumper. These instructions cover the removal of the bumper
and OEM tow package (if equipped) together as a single assembly. If you
prefer, you may remove the two items separately. (Figure 1)
2. Begin by removing lights from both sides of the license plate. From behind
the bumper locate each light. Twist 90 degrees and pull to remove the bulb
and socket from the housing.
3. Disconnect the trailer connector plug
and mounting plate (if applicable) by
removing the two bolts at the top of the
plate that attach the plate to the OEM Receiver cross beam (Figure 2). If
you find that you need to disconnect the wiring harness from the plug, the
factory connection will have a plastic plug with a retainer. The retainer
must “swing” open approximately 90 degrees to release the connection.
Tuck the harness and connector plug safely to the side so that it does not
get damaged during the install.
4. Use a 17mm socket to remove the bolts on either side that
attach the bumper frame mount to the frame (keep these
bolts, you will re-use them later). Do not fully remove the
forward most bolt, it only needs to be loosened to allow the
bumper to slide out the rear and will help position the
Warrior bumper during installation. There will be only
three bolts per side without the OEM Receiver, or five bolts
per side with the OEM Receiver (Figure 3).
Figure 1
Figure 2
Figure 3
Remove these bolts