CellarPro 2000VSi, Owner'S Manual

Page: 14 / 37

14
V4.18
•
Mount the unit in the upright position close to the ceiling inside the cellar. As warm air
rises to the top of the cellar, the cooling unit pulls the warm air through the evaporator coil and
removes the heat from the warm air. Once cooled, the cold air is discharged from the front of
the cooling unit and circulates through the cellar.
•
Slide the unit through from the outside of the cellar. CAUTION : Two people are
required to move the cooling unit, which is very heavy. Do not place the cooling unit
on unprotected bottle racks.
•
Mount level, or tilt the cooling unit slightly backwards. The rear of the cooling unit
should be level or slightly lower (1/8” max.) than the front of the cooling unit to facilitate the
flow of excess condensate to the drain line.
•
Use our adjustable mounting brackets to support and anchor the cooling unit to the framing in
the wall.
Use the (14) #10x1- 1/2” flat Phillips head wood screws provided to anchor the screws
into the studs and braces. The mounting brackets can be used either inside or outside the cellar
and can be used in three different locations, as shown in the following diagrams.
Please note: when installing this unit, you must select from the pre-drilled holes to attach the mounting
brackets. If you drill new holes into the case, you will damage the internal components of the cooling unit.