BEFORE YOU START
1-800-343-9463
1.
Inspect all components prior to installation.
If damaged or missing components are found, please contact your distributor
or CellarCool Customer Service at 1-800-343-9463.
2. The evaporator unit
requires a dedicated 1
20
V, 15-amp circuit
. The condensing unit
requires a dedicated
220
V,
15
-amp
circuit.
Use a surge protector with the unit.
Do not use a GFI
(ground fault interrupter) line or breaker.
3. Communication cable (18-5 thermostat wire) must be ran between the condensing unit and the evaporator unit. Only 2 of the
communication wires will be used. For 24V thermostat equipped systems an 18-5 cable must be used to connect the
thermostat to the evaporator unit.
4. You are
REQUIRED
to
install a drain line
to remove condensation from the evaporator unit.
5.
The warranty is not active until a warranty checklist has been received, reviewed, and approved.
6. The system is intended
for use in properly designed and constructed wine cellars.
Hire a professional wine storage
consultant with a valid contractor’s license to build your wine cellar.
7. CellarCool requires that all split systems be installed by a certified HVAC-R technician only. NATE or equivalent is
recommended.
If you encounter a problem with your CellarCool system, please refer to the Troubleshooting Guide. If you have any further
questions or concerns, or need technical assistance, please contact CellarCool’s Customer Service at 1-800-343-9463. Please be
sure all testing has been completed prior to contacting Customer Service. Please have your results ready for your representative.
Page 3
08/09/21
