Troubleshooting
15
What if the Signal Strength Indicator is blinking in red?
1. Please ensure that the SIM card is inserted correctly.
2. If yes, please login to the Web Management Page
(http://192.168.1.1)
with the Admin
password and key in
1234
as the PIN code.
3. To permanently disable the PIN code prompt, kindly refer to
Section 8: Enabling or
Disabling the PIN Code
The PC in a LAN mode cannot access Internet.
1. The power indicator is on, and the E961 is normally connected with the power adapter.
If the power indicator is off, you need to check whether the power is normally
connected.
2. If the signal strength indicator on the E961 panel is off, you need to check whether the
area is covered by WLAN.
3. If the area is covered by WLAN, you need to check whether the network mode is right.
See Chapter 9 “Configuring UMTS Settings” for info
rmation about network mode.
4. If the indicator of Ethernet interface blinks, the corresponding Ethernet interface is
normally connected. If the indicator is off, you need to check and ensure that the
corresponding Ethernet connection is normal.
5. You must
configu
re the correct PPP user name and PPP password when you access
the internet through the E961. Check whether they are correct, and see
“Configuring
PPP Pr
ofile Settings” for details.
6. If the DHCP service is disabled and the PC obtains the IP address dynamically, the PC also
cannot access the internet. You can change the mode to manually assign an IP address.
See “Configuring the PC Network.”
7. Check whether the driver of the network adapter is correctly installed.
8. If the preceding methods cannot solve the problem, please consult your service
provider.
t.
1. If there are interferences or shields near the E961, you can adjust the position of the E961.
When the signal strength is strong, you can move to the next step.
2. Check and record the following data on the PC’s network adapter: SSID, WEP type, and
key.
3. Check and record the following data on the E961: SSID, WEP type, and key.
4. Compare the data, the SSID on the network adapter should be ANY or be the same
with that on the E961. The WEP type and key on the network adapter and E961 should be
identical. Otherwise, you need to change the data on the network adapter.
40
