5.2.2.1.3.2. UDP CLIENT & SERVER CONFIGURATION IN CASE OF SLAVE DEVICE
Set operating parameters of UDP server for SLAVE device connected via serial port to ADA-14040, eg like on picture below. Set an
access to UDP server on e.g. 2101 port. Then select
Automatically send serial data
in section
UDP Client Settings
, this
automatically send received data by the use UDP client service to the MASTER device connected to LAN/WAN through e.g. ADA-
13020, ADA-13028L, ADA-13040, ADA-13110, ADA-14040.
On lists
Send data to the following network services
are addresses of network devices and ports to which will be send data. In
field:
-
Description
- enter e.g. location of the converter and MASTER device,
-
Send To
- enter IP address of e.g. converter, connected to MASTER device,
-
UDP Port
- enter the number of port on which is working UDP Server of converter connected to MASTER device and press
[Add]
In the section
Send data under any of the following conditions
is recommended to set parameters like on picture bellow.
For saving the configuration of UDP client and server for SLAVE device, press
[Apply]
.
Fig 22. Example configuration of ADA-14040 UDP server&client connected to SLAVE device
Attention !
Default port of serial port service is 2101.
If on the local network conflict with other network service using the same port, change number of port into another for the
service server of serial bridge and client in the server port configuration.
5.2.2.1.3.3. SERIAL PORT TRANSMISSION PARAMETERS
For proper operation of ADA-14040 with device connected to his serial port, should be set the same transmission parameters for both
devices.
Select
Basic Serial Settings
and enter
Baud Rate
,
Data Bits
,
Parity
,
Stop Bits,
the same parameter like has device connected to
the Wireless Serial Server.
5.2.2.1.4. SERIAL BRIDGE
Choosing the
Serial Bridge
profile enable direct communication between two devices connected to two ADA-14040 converters over
the network as if they were connected with a serial cable. A properly configured ADA-14040 will start automatically communication
with each other.
21
ADA-14040
