Cedar AZX+, Owner'S Manual

Page: 13 / 36

PAGE 7
FRONT-PANEL INDICATORS AND
CONTROLS
1 Power switch
Q
When
OFF
, the Series X+ is in standby mode.
Q
When
ON
, the Series X+ is powered up and operational.
The unit is not powered off completely unless the power lead is removed.
2 Input selector and
LED
s
Q
When
OUT
, the
AES/EBU
input is selected.
Q
When
IN
, the
SPDIF
input is selected.
If a Series X+ fails to lock to an incoming signal, the
LED
will flash.
3
BRX
+ Output attenuator and
LED
s
Q
When
OUT
, no attenuation is applied.
Q
When
IN
, the signal is attenuated by 3dB.
Use of the
BRX
+ processor on signals close to full-scale may result in slight
clipping. This can be avoided using the attenuator.
4
BRX
+ Process
ON
/
OFF
and
LED
s
Q
When
OUT
, the input signal is echoed at the outputs.
Q
When
IN
, the processed signal is directed to the outputs.
Use this control for before/after monitoring of the signal. The signal delay and
attenuation are not affected by this control.
5–13 Process controls
Refer to the section specific to each model: the section on the
BRX
+
starting on page 9, and on the
AZX
+ starting on page 13.
14 Power indicator
Q
Upper
LED
illuminated indicates that the unit is operational.
Q
Lower
LED
illuminated indicates that the unit is in standby mode.
Either
LED
illuminated indicates that power is applied to the unit.