cecotec CONGA WINROBOT 870, Instruction Manual

Page: 11 / 15

ENGLISH
21 CONGA WINROBOT 870
1. Check out whether the cleaning cloth is too dirty.
2. Glass stickers and window film can also affect the friction factor.
3. If a window is cleaned many times, its surface becomes very slippery.
4. The surface of the window will become slippery if it is cleaned several times in low humidity
environments, such as in air-conditioned rooms.
5. While starting, press , or and place the device 10cm away from the window
frame.
Q2
: Conga WinRobot 870 slips and cannot detect the upper frame of the window in “Auto Up
then Down”( ) mode.
Ans.
: Press the key and switch to or auto mode.
Q3
: Conga WinRobot 870 cannot clean the whole window.
Ans.
: Press or auto mode to continue cleaning.
Q4
: Conga WinRobot 870 slips and cannot get to the upper window frame.
Ans
.: The friction factor is too low.
1. The cause might be glass stickers or window film.
2. The cleaning cloth might be too wet.
3. If the window is cleaned many times, the glass surface will become slippery.
4. The glass surface will become slippery if it is cleaned several times in low humidity
environments, such as in air-conditioned rooms.
5. While starting, press , or and place the device 10cm away from the window
frame.
Q5
: Conga WinRobot 870 does not move smoothly, or it moves irregularly.
Ans.
:
1. The cleaning cloth is too dirty. Please change the cleaning cloth.
2. The surface of the window has different friction factor areas, due to stickers or window
films. Please use the device in a single area.
3. The screw of the cleaning wheel might be loose, tighten it.
Q6
: After cleaning, circle marks remain on the window surface.
Ans.
: The cleaning cloth is too dirty. Please change the cleaning cloth and clean again.
Q7
: What to do if the Conga WinRobot 870 stops at a high area with no electric power supply,
and the alarm and red light are flashing.
Ans.
:
1.
Pull the Conga WinRobot 870 back with the safety rope. Lightly pull from the safety rope