CONGA 8090 ULTRA
|
31
ENGLESK
saves the full map and those that have not been completed, and once it is
charged again, it resumes the cleaning cycle from the point it has stopped
until it maps the whole surface. The robot keeps on mapping constantly,
therefore it adapts independently to each house’s features and continuously
improves previous maps.
4. Operation
- Once the robot’s light indicator changes from oscillating orange to steady
blue, the battery is fully charged and the robot is ready to operate.
- The robot cannot operate with low battery.
Recommendations
- Remove all cables and obstacles from the floor before operating the robot
in order to avoid accidents and damage.
- Set stairs as restricted areas.
Robot buttons.Fig. 12.
Automatic mode
• Press the power button on the robot for it to start cleaning automatically,
first a cleaning cycle in Edge mode and then another cycle in an organised
zigzag motion, recognising which areas it has cleaned and which ones it has
not. The robot will automatically plan the cleaning route as it is cleaning. If
during this mode the robot is controlled manually, the robot will calculate
the route again and could go through previously cleaned areas. In order
to ensure efficient cleaning, do not operate it manually during auto mode
cleaning.
• Thanks to its Total Surface 3.0 technology, if the battery is low during
the cleaning cycle, the robot will smartly return to the charging base
automatically and, once it is fully charged, it will resume the cleaning
process from the same point, offering a highefficiency cleaning. During
cleaning, the robot will stop briefly to evaluate the area and calculate the
cleaning route (this stop will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, therefore
it might leave the room where it is cleaning to finish off the delimited area.
Do not worry, the robot will clean all the accessible surface.
Back home mode
- Press the back home button.
