68/109
3301065/A
3�7�1
Wire feeder panel description
Fig. 9
AN - Knob
Press knob AN to select LEDs
AQ AP AO
. Turn to adjust the current/wire speed/thickness shown on display
AR�
AR - Display
This shows the value of magnitudes adjusted by means of knob
AN�
AO - LED Thickness
Select LED
AO,
display
AR
shows the thickness in mm of the workpiece to be welded in relation to the set current
and wire speed. Active in synergic MIG/MAG processes.
AP - LED Wire speed
Select LED
AP,
display
AR
shows the welding wire speed in metres per minute. Active in synergic MIG/MAG
processes.
AQ - LED Welding current
Select LED
AQ,
display
AR
shows the welding current in amps.
AW - Knob
Press knob
AS
to select LEDs
AT AU AV
. Turn to adjust the respective arc length/impedance values shown on
display
AS�
In MIG/MAG processes with LED
AT
on, when
AW
is turned, the selection automatically shifts to LED
AU
and arc
length is adjusted.
AS - Display
This shows the value of magnitudes adjusted by means of knob
AW�
AT - LED Welding voltage
With LED
AT se
lected, the arc voltage is shown on display
AS
. When the arc is off, the voltage displayed is the
preset voltage. During welding, the voltage measured by the power source is displayed.
AU - LED Arc length
Select LED
AU,
display
AS
shows the welding arc correction (see section 4.3.3).
AV - LED Impedance
Select LED
AV,
display
AS
shows the impedance correction (see section 4.3.3).
BA - LED Globular position
With MIG Short process selected, this indicates that the pair of current and voltage values chosen for welding may
give rise to unstable arcs and spatter, material transfer in globular position.
