CEAM IF324, Operating Manual

Page: 11 / 24

IF324_5A808_UK_M1 ® Copyright CEAM Group
CEAM Control Equipment 11
4 – Display
1) Indicator of the Present Measurement
2) Data Hold Indicator
3) Laser ON
4) Indicator of the measured Temperature
5) Lock Abbreviation
6) High Alarm and Low Alarm Abbreviation
7) Symbols MAX – MIN – AVG – DIF
8) Indicator of the Temperature MAX – MIX – AVG - DIF
9) Indicator of Value Emissivity Or Temp. T/C
10) Indicator Abbreviation Emissivity Or T/C
11) USB Abbreviat. (Active gate to transmit data to the PC)
12) Low Power Indicator
13) Indicator °C / °F
14) Data Logger Function Abbreviation
5 – Keyboard
1) Key On-Off Backlighting & Laser
2) Key UP (EMS – HAL – LAL)
3) key DOWN (EMS – HAL – LAL)
4) Key MODE – Rotation Instrument Functions and Display
5.1 – Instrument General Functionalities
5.1.0 – Preamble, The instrument can be activated in the following modalities:
MEASURE: This modality is activated simply pressing the trigger (Ref. Cap. 3 – Pos.9), during this period the
instrument visualize on the display the word SCAN (Ref. Cap. 4 – Pos.1), for short this period would be
denominated MEASURE
HOLD:
This mode activates itself automatically, when you release the trigger (Ref. Chap.3- Pos.9) after the
measurement, and if you don’t press any key during this time, and you did not disable the energy save
function, the instrument automatically turns off after few seconds, during this phase the instrument visualize
its state through the word
HOLD on the display (Ref. Chap.4 – Pos. 2), for short, this phase can also be called
HOLD
5.1.1 – During the MEASURE , pressing again and again the key MODE (Ref. Chap.3 - Pos.8) you visualize in
sequence the values got respectively: MAX (Maximum), MIN (Minimum), DIF (Differential), AVG (Average), LOG.
5.1.2 – During the Infrared MEASURE (Without Inserted Thermocouple), it is possible to adjust the value of
Emissivity, pressing the arrow keys UP – DOWN (Chap.5 – Pos. 2 & 3); the modified value is visualized on the
display (Ref. Chap.4 – Pos.9)
5.1.3 - When in OLD , you can select the temperature display in °C or °F pressing the keys UP & DOWN (Ref.
Chap.5 – Pos.2 &3)