3. Warranty and Safety Conditions
*
WARNING:
The electronics in the power supply system are designed for an indoor, clean environment.
When installed in dusty and/or corrosive environment, outdoor or indoor, it is important to:
•
Install an appropriate filter on the enclosure door, or on the room’s air control system.
•
Keep the enclosure door closed during operation.
•
Replace the filters on a regular basis.
Important Safety Instructions and Save these Instructions.
•
The inverter system/rack can reach hazardous leakage currents. Earthing must be carried out prior energizing
the system. Earthing shall be made according to local regulations.
•
Prior to any work conducted to a system/unit make sure that AC input voltage and DC input voltage is
disconnected.
•
CAUTION
– Risk of electric shock. Capacitors store hazardous energy. Do not remove cover until 5 minutes after
disconnecting all sources of supply.
•
CAUTION
– Disconnection of the DC source is required to de-energize this unit before servicing.
•
Maximum operating ambient temperature is 40º C (104º F).
•
AC and DC circuits shall be terminated with no voltage / power applied.
•
Some components and terminals carry high voltage during operation. Contact may result in fatal injury.
•
Warning labels must not be removed.
•
Never wear metallic objects such as rings, watches, bracelets during installation, service and maintenance of
the product.
•
Insulated tools must be used at all times when working with live systems.
•
When handling the system/units pay attention to sharp edges.
•
ESD Strap must be worn when handling PCBs and open units.
•
The inverter system/rack is not supplied with internal disconnect devises on input nor output.
•
REG systems can be seen as independent power sources.
•
In case of output short circuit, the inverter must disconnect in maximum 15 seconds. However, an external
protection must be provided in order that the short circuit protection operates within 15 seconds.
•
The equipment must be installed and commissioned by skilled technicians according to instructions in this
manual.
•
Local regulations must be adhered.
* These instructions are valid for most CE+T Products/Systems. Some points might however not be valid for the product described in this manual.
Warranty and Safety Conditions
6
– e-one 10 - 48/230 - User manual - v1.2
