4] ASSEMBLY
4
cdvigroup.com
Position the box-section backplate, complete with
pre-fi tted electro-magnetic locks, on to the door
frame - ensure the positioning will allow for the
architectural handle to close securely over the
section. Once you are satisfi ed with the position,
mark the vertical and horizontal holes, then drill as
required. Take note of the cable entry holes, and
feed the cables through. Fix the section into place,
then wire the electromagnetic locks in accordance
with the wiring schematic in Section 5. Fit the box
section cover into place, fi x the end caps and secure
with the screws provided. To fi nalise the assembly,
tighten all fi xings, and protect the handle fi xing
section by fi tting the cover and end caps.
With the door closed, position the architectural
handle onto the edge of the opening leaf of the door,
ensuring the handle covers the box-section. Mark
the vertical and horizontal holes, drill as required,
then temporarily fi x the handle leaving a small gap
around the box section – check the alignment of the
magnets in the box section with the armatures in
the handle. Adjust if necessary, then once satisfi ed,
secure the handle by completing the fi xings.
Insert the end caps and secure.
EN
BO600RP - BO600RH
Vertical & Horizontal retrofi t housing
INSTALLATION MANUAL
BO600RH
