These products should not be installed:
1. In direct sunlight.
2. Adjacent to a heat source (oven or radiator).
3. Below a hob unit.
4. In a damp or wet environment
Where a continuous plinth is to be used, it is necessary to cut a section
out so that the ventilation slots at the front of the appliance are not
obstructed in any way as per Fig 3.
This appliance is designed to fit under worktops between 830 –
8
85
mm in height, using the adjustable plinth plate to ensure that the
feet are concealed from view.
IMPORTANT: Failure to follow the instructions regarding installation
and ventilation may invalidate the warranty supplied with your
appliance.
To install the handle
IMPORTANT: DO NOT REMOVE
THE SCREWS FROM THEIR
POSITION IN THE DOOR (Fig. 4)
PRIOR TO FITTING THE
HANDLE AS FIXINGS MAY
DROP INTO THE DOOR. The
door seal holds the screws in
place during transit. Do not
overtighten the screws, and do
not use power tools to install
the handle.
Fig. 4
Door glass
Screw hole + screw
60
o
M
in.
Screw
Pivot plate
1. Peel back the door seal from the glass side to expose the screw
holes, as per Fig. 4. Place a screwdriver against the screw and
hold it in position.
2. Carefully locate the handle over the fixing screw.
3. Using a screwdriver, tighten the securing screw to fix the handle.
Repeat with the remaining handle fixing screw.
IMPORTANT: Take care, when installing the handle, not to damage
the door. Any damage caused may not be covered by the warranty
supplied with your appliance.
Reversing the door
The following instructions are based
on a wine cooler with the door hinged
on the right hand side. We strongly
recommend seeking the help of at least
one other individual during this process.
Before starting the reversal process,
ensure that you have the left hand
upper and lower hinges. These are
supplied with your product.
Do not tilt the appliance backwards
further than an angle of 60° (Fig.5).
Fig. 5
Fig. 6
Instruction Manual |
1
7
Instruction Manual |
1
6