12
| Instruction Manual
Instruction Manual |
13
Removing the shelves (WCCF0302, WCCF0602 & WCCF0622)
• To remove a shelf from the WCCF0302, WCCF0602 or
WCC0622, first remove all bottles from the shelf, then pull the
shelf forwards until the groove on either side of the shelf is
level with the plastic peg on either side of the cabinet (as
shown in Fig 2). Then lift the shelf up and pull forwards.
• To replace the shelves, follow
the steps above in reverse order.
Cleaning
IMPORTANT: Always disconnect the appliance from the mains electri-
cal cupply before any cleaning or maintenance
• Do not use abrasive products or detergents
. After washing, rinse
and dry thoroughly.
• The exterior of the appliance and the door seal should be cleaned
using mild soapy water and dried thoroughly.
• The interior cabinet should be cleaned regularly using a
solution of bicarbonate of soda and lukewarm water.
• Clean the shelves separately by hand using soap and water. Do not
put them in the dishwasher.
• Ensure that the cloth is only moist when cleaning the
control panel and electrical parts, and that all water is
thoroughly dried off before reconnecting the power.
• Once cleaning is complete, reconnect the mains electrical
supply.
• If the appliance is not to be used for prolonged periods of time, un-
plug and clean the appliance thoroughly. and ensure dry. The door
should be left slightly ajar to prevent the formation of odours, mould
or condensation.
Temperature alarm
If the temperature rises or falls outside the set temperature range,
an alarm will sound and the display may show a fault.
This may be because:
• The wine cooler has not yet reached the set temperature (when
first switched on) or is taking a long time to reach it.
• There has been a power failure.
• The wine cooler has been overloaded or damaged.
• The door is not closed properly.
• The temperature sensor has failed (see page 15).
Please note:
If the wine cooler has overheated and the alarm is
sounding because of this, the system will shut down automatically
after 6 hours of the alarm tripping. The warnings will continue
however.
Troubleshooting
If you have any problems with your appliance, you should check
the troubleshooting guide prior to calling CDA Customer Care.
If the appliance is not working, check:
• There is power to the appliance
• The house fuses or circuit breakers are intact and the fuse in
the plug has not blown.
• The plug socket is functioning correctly. To check this, plug
another electrical appliance in to see if the socket is working.
• The ambient temperature is between 16°C to 38°C.