22
| Instruction Manual
Instruction Manual |
23
8. Adjust the wine cooler feet so that you achieve the desired
height for the cooler. If needed, re-attach the extendable plinth
section with the four screws that were removed in step 2. Stand
the wine cooler up steadily - if the extendable section will foul
the floor or similar, remove it.
Allow the wine cooler to stand
for 24 hours before plugging it in.
This will help to prevent
damage to the system.
Adjusting the plinth
The plinth/grill for this appliance comes with an adjustable
section. The process for adjusting the plinth trim is simple and is
achieved by following the steps below. Perform these steps once
the appliance is standing on all four feet and do not put weight on
the plinth.
1. Loosen the two screws on each side of the plinth trim (four
altogether - Fig. 17).
2. Carefully guide the front trim down until the desired height is
achieved.
3. Tighten the screws
Electrical information
Warning! This appliance must be earthed.
The mains lead of this appliance has been fitted with a BS 1363A 13
amp fused plug. To change a fuse in this type of plug, follow the
steps below:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into
the fuse cover.
3. Replace fuse cover.
Important:
Do not use the appliance without the fuse cover in
position.