CDA VK970BL, Installation, Use And Maintenance Manual, Page: 23 / 32

23
Installation
When correctly installed, your product meets all safety
requirements laid down for this type of product. However, special
care should be taken around the rear or the underneath of the
appliance as these areas are not designed or intended to be
touched and may contain sharp or rough edges that could cause
injury. Please wear adequate PPE (Personal Protective Equipment).
The appliance can be installed under a worktop or in a tower unit with
the appropriate dimensions for recessed installation.
Study the installation diagrams on pages 24 and 25 carefully. Take
care to ensure that you follow the ventilation requirements.
Centre the oven in the unit, ensuring that there is as much of a gap
as possible, for ventilation purposes, between the appliance and the
surrounding unit. The material of the unit supporting the appliance
must be heat resistant (or covered with a heat resistant material) to at
least 75°C above ambient temperature (ideally 105°C +).
Once the appliance is in place within the unit, secure it using two
screws. There is one screw hole on either side of the appliance, just
below the control panel and behind the
door.
Do not use your appliance immediately
after moving it from a cold location, as
condensation may cause a malfunction.
Wait approximately 1-2 hours before use.
Fig. 2