CD Automation REVEX 1Ph 30A, User Manual

Page: 46 / 60

46
REVEX
1PH from 30A to 40A
User’s manual
To confi gure and monitor the digital inputs:
Digital input states and functions :
show whether each input detects an open or closed
circuit and the function the input performs.
Digital Input States and Function Selectors :
set the function for each digital input. Click DI1 or DI2 to
expand the options.
Status and Setup Indicators:
Digital input status : light on when the input is a closed circuit
Enable indicator : light on when the power controller is enabled
Enable/Disable button: click on to enable the
power controller if a digital input is not confi gured
for this function
ON indicator : light on when there is demand for
the output to be on
SC indicator : light on when there is a shorted SCR
alarm active
HB indicator : light on when there is a heater break
alarm active
TH indicator : light on when the heat sink over
temperature alarm is active
I Lim indicator : light on when the load current
exceeds the current limit setting
Unit Size : indicate the maximum rated current of
the power controller
Max Volt : indicate the maximum rated voltage for the power controller
V Aux : indicate the voltage the auxiliary input is set to use for powering the electronics
Input Type1 : indicate the signal analog input 1’s type
Input Type2 : indicate the signal analog input 2’s type
DI1 : indicate digital input 1’s function
DI2 : indicate digital input 2’s function
Firing : indicate the fi ring type the power controller is set to use
Feedback : indicate the feedback type the power controller is set to use
Data Log : indicate the Data Log status.
Buttons setup options:
Firing : view and set the fi ring type and the associated
parameters
Feedback : view and set feedback type
Communication : view and set communication options
for ports, protocols and fi eldbus
Confi gure and monitor the analog inputs:
Analog Input 1 : click Ai 1 to view the signal type
Input Local/Remote selection button : click to toggle between using the signal received at analog input 1
(remote) or the slider (local) to set the set point.
Reference : drag the slider, click the increment (+) or decrement (-) buttons or click one of the three
percentages (0%, 50% or 100%) to set the set point when the set point source is set to local.
Analog Input 2 : click Ai 2 to view the signal type and
function
To confi gure and monitor the power controller:
Power Request : show the set point signal from analog
input 1.
The value is a percent of full scale or can be set with the
reference slider
Soft Start Time : show the time over which set point
changes are ramped
Output Scaling : show the scaling applied to the set point
signal before it is used by the control loop
Voltage indicator : show the RMS load voltage
Power indicator : show the RMS load power
Current indicator : show the RMS load current
Current Limit Set : indicates the current limit set point
Bakeout button : click to view and set the heater bake out
feature options
Load Calibration : set and view the nominal line voltage
and nominal load current settings for the application.
NOTE! The Load Calibration settings, Load Voltage and Load Current defi ne 100% power for the load.