User manual
v1.1
P
H
ILEO
P
RO
CCEI
page
9
INJECTOR INSTALLATION
The injector is used to inject the required amount of acid or alkaline solution to correct
the pH of the water. The injector must be positioned after the pH probe and as close as
possible to the outlet into the pool.
Clear tubing coming from
doser pump output. The
tube is fitted on the
injector by tightening the
upper nut of the injector.
The injector must be
screwed onto the clamp
saddle with TEFLON
Clamp saddle to be
fitted onto the piping.
INSTALLATION DIAGRAM
The various PHILEO components to be onto the piping of the swimming pool are:
- The pH probe, which must be positioned directly after the filter with eventually other
measuring instruments. To this end, a 63 or 50 mm clamp saddle is used.
- The acid or alkaline solution injector is positioned just before the outlet into the pool.
To this end, a 63 or 50 mm tightening band is used.
If a heater and an electrolytic cell are used, they should be placed between the pH
probe and the injector (acid or alkaline solution), as shown in the diagram below.
