User manual
v1.1
P
H
ILEO
P
RO
CCEI
page
5
pH MENU
With this display the user has access to different possible settings. To enter in the
menu press the
key.
The user can here configurate the operation of the pH regulation.
To scroll down the menu use the keys
and
. The different displays are the
following:
pH setting = 7.2
This screen is used to set the pH set point. To vary this value use the keys
and
. To validate the value press the
key. To exit the menu without validation press
the
key
pH dosing= pH-
With this screen you can choose the regulation mode. Press the
key and choose
the requested mode with the keys
and
.
The different adjustment modes are as follows :
- pH- MODE: For injecting an acid solution and hence lower pool pH. The pump starts
up when the water pH exceeds the pH set point.
- pH+ MODE: for injecting an alkaline product and hence increasing pool pH. The
pump starts up when the pH of the water is less than the pH set point.
- ON MODE: For injecting an alkaline or acid product continuously and with no setting.
This mode can be used for priming the pump.
- OFF MODE: for stopping product injection. This mode can be used when wintering,
for example.
To validate the mode press the
. key To leave the programme without
validating press the
key.
V/24h=2.0L
(pH)
This screen allows the maximum allowable daily injection volume to be set.
To this end simply press the
key and choose the daily volume using the keys
v
and
.
Volume adjustment is in litres. To validate the set volume, simply press
. To leave
the programme without validating the mode, press
.
ATTENTION If this value is left at 0 litre, there would be no limit on the volume
injected per day. Therefore, it would be wise to set a value for this parameter.
