CCI.GPS
– Troubleshooting
18
5 Troubleshooting
5.1 Errors during operation
The following overview shows you possible errors when operating with CCI.GPS,
their possible cause and how to rectify them:
Error
Possible cause
Rectification/approach
No GPS data are displayed in
GPS info.
No power supply at the
GPS receiver
Check the power supply to
the GPS receiver
GPS receiver not connected
to the terminal
Check the
connection of the GPS
receiver to the terminal. If
serial data are to be used,
the RS232-I interface must
be used. If CAN data are to
be used, the receiver must
be connected to the CAN-
Bus
.
Incorrect GPS source
selected
Under GPS settings (see
chapter 4.3) check whether
the GPS source is selected
that is currently being used.
Incorrect baud-rate set
When using serial data
under GPS settings (see
chapter 4.3), set the same
baud-rate with which your
receiver is configured.
Incorrect configuration of
the receiver
Check which configuration
is necessary for your
application (see for example
Chapter 3.2.2.1
of the
CCI.Command
operating
instructions) and compare
this with the current
configuration of your
receiver. To see how the
receiver is calibrated, refer
to the
operating instructions of
your GPS receiver.
Incorrect assignment of the
cable wiring
Check that the wiring
assignments of your cable
match the assignments
given in these instructions
(see chapter 3.1.1.1).
Summary of Contents for CCI 100
