10
FIK19R Rimless flipIT ® by SMaRTdesks® www.smartdesks.com ©2012 CbT Supply, Inc. 800-770-7042
Almost done.
Everything is complete, except for install-
ing the LCD monitor, CPu, modesty panel
and doing the wire management.
once the LCD monitor is installed, the lid
will need to be adjusted flush with the
top.
Turn the table on its feet to complete the
installation.
use the 4 screws provided with your monitor to install the VESa
mount. The VESa mount captures the bracket and gravity does the
rest. a spring-loaded pin holds the monitor in place at every angle.
Close the lid CaREFuLLy, because the gas spring is not connected.
now its time to fine tune the flipIT Lid.
Install the monitor
Make lid flush
use a straight edge as a reference. use the
weight of the monitor to make the front rest
adjustment first.
Monitor weight may compress the pad,
causing the lid to sink in.
Use 3/8” open end wrench and 5/32” hex key to loosen,
adjust and re-tighten the rest.
Summary of Contents for flipIT RIMLESS
Page 12: ......
