CBS ArcSafe RRS-3 WL, Installation And Operation Manual

Page: 7 / 16

RRS-3 WL
Installation and Operation
5
2 Operation
A
TTENTION
!
Please ensure that all cables are clear of moving parts. Failure to do so may result in damage
to cables and/or actuator.
A
TTENTION
!
Please ensure that the batteries to the RSO-IV are fully charged or that the unit is plugged into
AC power.
For detailed instructions on the operation of the RSO-IV please see the RSO-IV Manual.
1. Ensure that the RRS-3 is properly installed. See the In-
stallation section of this manual for detailed instruc-
tions.
2. Connect the cable from the RSO-IV to the motor control
box on the RRS-3
3. Turn the power switch on the RSO-IV to the ON position.
4. Program the settings for the RRS-3 into the RSO-IV.
These settings can be found on the placard on the RRS-
3. For more information on programming the RSO-IV
please refer to the RSO-IV Technical Manual.
5. Exit the arc flash boundary.
6. Once the current limits have been properly set, press
and release the REMOVE button on the RSO-IV control
panel or remote pendant to rack the breaker out.
7. Press and release the INSTALL button on the RSO-IV
control panel or remote pendant to rack the breaker in.